How to Install Front Mounted Intercooler on Nissan R35 GTR

Posted on 27 December 2013 by admin

Download How to Install Front Mounted Intercooler on Nissan R35 GTR – 1. Position the car ideally on a 2 post lift, or jack it up using the middle jacking point under the engine and support on axle stands at the jacking points on the sills. Removing both front road wheels and arch liners may make installation easier but it’s not necessary. 2. Remove the 8 push in clips between the slam panel and the bumper and remove the trim from the car. Pop the side repeaters out of the ends of the bumper by inserting a screwdriver behind them and levering out until the metal tab is released, then twist the bulb holder to remove the repeater. 3. Remove the 4 push in clips holding the bottom edge of the arch liner to the bumper, then pull back the edge of the liner from the bumper and undo the single 10mm bolt. With the arch liner pulled out of the way, you will be able to easier access the other bolts holding the bumper to the wing. We found it easiest to use a long extension on a 3/8” drive to get onto the bolt. 4. Remove the rubber bungs along the front edge of the bumper (10), and the attached undertray (4 at the front, 3 at the rear).

Comments are closed.

Auto Repair Manual
Free Auto Repair Manuals PDF Download
www.aurepman.com

Auto Service Manual
Free Auto Service Manuals PDF Download
www.autoserman.com

Service & Repair Manual Free Download
Automotive, Computer, Printer, HandPhone, Tablet, Tips and Tricks...etc. Visit US ...
www.okemanual.com

Car Repair Manual
Free Car Repair Manuals PDF Download
www.carrepman.com

Car Service Manual
Free Car Service Manuals PDF Download
www.carserman.com

Auto Repair Magazines
Free PDF Download & Review
www.autorepmagz.com

Auto Service Magazines
Free PDF Download & Review
www.autosermagz.com

Ndarzone
Ndarzone | Article, New and Science
ndarzone.blogspot.com

suggest listing
PR5 Free Web Directory - Submit URL >>
www.addurl.nu

Ads by Iskandar

You might also likeclose